Home
Help Desk
Books |
Seminar Venue: |
Lucent Training
Center The Summit at Westchester 100 Summit Lake Drive, 2nd Floor Valhalla, NY 10595 Phone: (914) 742-2100 Fax: (914) 742-2112 |
Directions: |
By Air The Valhalla/White Plains area is served by three airports: From Westchester County/White Plains Airport Approximately 8.5 miles from the Training Center and White Plains On leaving the airport continue straight 0.9 miles to Route 120. Turn right onto Route 120 North. Proceed 1.6 miles to Route 22. Turn left onto Route 22 South. At the second light, turn right onto West Lake Drive over the Kensico Dam to Columbus Avenue. Bear right on Columbus Avenue. Go to the fourth traffic light (count all lights, blinking or full) and turn left into the Summit At Westchester complex and follow signs for number 100. Park in level P2. From LaGuardia and Kennedy International Airports
Directions to the training center: Take the Whitestone Bridge to the Hutchinson River Parkway to I-287 West and follow the directions for "Via I-287 West" below. By Car Via Saw Mill Parkway (Passenger Cars Only) Take the Saw Mill Parkway to Exit 27, Marble Avenue/Thornwood. (If traveling south, exit left. If traveling north, exit right.) At the end of the exit ramp bear right onto Marble Avenue. Proceed 2.2 miles along Marble Avenue/Kensico Road/Columbus Avenue. Turn right at the Summit at Westchester complex and follow signs for number 100. Via Bronx River Parkway (Passenger Cars Only) Take the Bronx River Parkway to the Stevens Avenue exit. (If traveling south, exit left. If traveling north, exit right.) Follow Stevens Avenue to the third traffic light. Turn left onto Columbus Avenue. Go approximately 200 yards to the traffic light and turn left into the Summit at Westchester complex. Follow signs for number 100. Via Taconic State Parkway South (Passenger Cars Only) Take the Taconic State Parkway South to the Bronx River Parkway South. Proceed .8 mile to the Stevens Avenue exit and follow directions above. Via I-684 I-684 to Exit 3, Armonk. Take Route 22 South for 5.1 miles to West Lake Drive. Turn right onto West Lake Drive and proceed over the Kensico Dam to Columbus Avenue. Bear right onto Columbus Avenue. Go to the fourth traffic light (count all lights, blinking or full). Turn left into the Summit at Westchester complex and follow signs for number 100. Via I-287 East from Tappan Zee Bridge - option 1 After bridge toll proceed to Exit 8 (Cross Westchester Expressway/I-287 to New England). Take I-287 to Exit 6. At the end of the exit ramp, turn left onto Rte 22 North. Proceed approximately 2 miles. At the seventh traffic light turn left onto West Lake Drive and proceed over the Kensico Dam to Columbus Avenue. Bear right onto Columbus Avenue. Go to the fourth traffic light (count all lights, blinking or full) and turn left into the Summit At Westchester office complex. Follow signs for number 100. Via I-287 East from Tappan Zee Bridge - option 2 (Passenger Cars Only) After bridge toll proceed to Exit 8 (Cross Westchester Expressway/287 to New England). Proceed .7 mile to Exit 1, Saw Mill Parkway (SMP) North and follow directions above "Via Saw Mill Parkway." You may park on parking level 2 in any unmarked space. Via I-287 West from Connecticut Take I-287 West to Exit 7. Stay in right lane on exit ramp. Proceed through the first light bearing right onto Route 22 North. At the second light continue North on Route 22. At the third light turn left onto West Lake Drive and proceed over the Kensico Dam to Columbus Avenue. Bear right onto Columbus Avenue. Go to the fourth traffic light (count all lights, blinking or full). Turn left into the Summit at Westchester complex and follow signs for number 100. From the Throgs Neck Bridge - Queens and Long Island - option 1 Take I-95 North to I-287 West and follow directions above "Via I-287 West from Connecticut." From the Throgs Neck Bridge - Queens and Long Island - option 2 (Passenger Cars Only) After toll follow signs to I-95 North to Hutchison River Parkway. Take Hutchison River Parkway North to I287 West and follow directions above "Via I-287 West from Connecticut." From the Whitestone Bridge - Queens and Long Island - option 1 (Passenger Cars Only) After toll take the Hutchison River Parkway North to I-287 West and follow directions above "Via I-287 West from Connecticut." From the Whitestone Bridge - Queens and Long Island - option 2 After toll proceed North. Follow signs for I-95 North. Take I-95 North to I-287 West and follow directions above "Via I-287 West from Connecticut." You may park on parking level 2 in any unmarked space. |
|
Nearby Accommodations: |
Ramada Inn Elmsford 540 Saw Mill Rover Road Elmsford, NY 10523 Phone: (914) 592-3300
Ramada Inn Armonk Ask for Lucent Technologies training rate of $127/night. Courtesy shuttle to Training Center and Westchester County airport is available.
Rye Town Hilton Ask for Lucent Technologies training rate of $169/night. Courtesy shuttle to the Training Center and Westchester County airport is available. Please book this service in advance.
Crowne Plaza Ask for Lucent Technologies training rate of $143/night. Courtesy shuttle to the Training Center and Westchester County airport is available.
Marriott Westchester
Courtyard by Marriott
Tarrytown House
Renaissance Westchester Hotel Ask for Lucent Technologies training rate of $165/night. Specifiy code LCTJ at time of reservation. |
The Resource Center for Customer Service
Professionals
PO Box 401, Western Springs, IL 60558
Tel: (708) 246-0320 Fax: (708) 246-0251
Copyright © 1997-2000 Resource
Center for Customer Service Professionals. All rights reserved.
Last modified September 10, 2000
Web Site by Software Company Restructuring Services (708) 246-0320